Kabuto Japan RT33, Инструкция по эксплуатации

Страница: 14 / 29

ENG-12
Screw-inserting
hole
Screw-inserting
hole
Helmet
Fig.2 Fig.3
2.Place the Shield Ratchet in the hollow
space on the side of the helmet and
align the mounting holes on the shield
ratchet with the mounting holes on the
helmet (Fig. 2).
3.Fasten both Shield Ratchet Screws
clockwise securely. Repeat the
same procedure on the other Shield
Ratchet. Then the Shield Ratchets are
installed (Fig. 3).
CAUTION!
•Do not fasten the Shield Ratchet Screws too tight. Too much tightening of the
screws may damage screws and other parts.
•Fasten the Shield Ratchet Screws by applying the screwdriver vertically to the
screws. If the screws are fastened by applying a screwdriver diagonally, the
threads may be stripped.
•The Shield Ratchet is an important part for open/close the shield. Install the
Shield Ratchet securely. After the installation is completed, check to see that the
shield can be closed to the lowest position and opened and closed correctly.
•Check and fasten the Shield Ratchet Screws regularly. Riding with the loosened
Shield Ratchet Screws is very dangerous as the shield may be removed while
riding.
WARNING!
ENG
Shield Ratchet
Shield Ratchet Screw