Kabuto Japan RT33, Инструкция по эксплуатации

Страница: 17 / 29

.
3. Make sure if the overall silicon seal of the Pinlock
®
Original Insert Lens is
attached firmly to the shield by mounting the shield on the helmet. If there is any
space between them, refer to “How to Adjust Pinlock ®
Original Insert Lens after
Attachment” and adjust the lens.
4. Peel off the protective film on the Pinlock
®
Original Insert Lens.
1. Remove the shield from the helmet.
2. Remove the Pinlock
®
Original Insert Lens from
the eccentric pins with flexing the shield. (Fig.6)
* Please read carefully the “CAUTION” and the “CAUTION *Pinlock ® Original Insert Lens”.
Adjust the Pinlock
®
Original Insert Lens if there
is any space between the lens and the shield.
1. Remove the shield from the helmet and
detach the Pinlock
®
Original Insert lens from
the shield.
2. Adjust the eccentric pins by turning them with
a tool. (Fig. 7)
3. Fit the Pinlock
®
Original Insert Lens back on
the shield. Make sure the Pinlock® Original
Insert Lens and the shield do not have any
space in-between after attaching the shield on
the helmet. If there is any space please follow
the same steps again.
*Please mount the shield on the helmet when checking if the Pinlock
®
Original Insert Lens is attached firmly to
the shield. Otherwise, the shield might be spread out by the pressure from the lens and it cannot be assured if
the lens has attached on the shield firmly.
[How to Remove Pinlock
®
Original Insert Lens]
[How to Adjust Pinlock
®
Original Insert
Lens after Attachment]
Section view
of shield:
Protective film
Pinlock® Original
Insert Lens
Silicon seal
Silicon seal
Shield
Eccentric pin Eccentric pin
CORRECT
WRONG
Shield
Face the eccentric pins inwards
Face the eccentric pins outwards
Pinlock® Original Insert Lens will be loose.
Pinlock ® Original Insert Lens will be pushed out and there would not be
any space between the Pinlock ® Original Insert Lens and the shield.
Eccentric pins
*with no space
Make sure the Pinlock ® Original Insert Lens to
be fit inside the chase.
Facing the eccentric
pins inwards
Facing the eccentric
pins outwards
Loosening the Pinlock
®
Original Insert Lens
Pinlock
®
Original Insert Lens is pushed out
and will be in close contact with the shield.
ENG-15
Fig.5
Fig.6
Fig.7
ENG