Kaba SIMPLEX 5000 CYLINDRICAL, Руководство по установке

Страница: 9 / 24

9
I-1 Make certain the lever catch is up as shown (c).
The lever catch should be flush around the
outer diameter of the outside driver. Make
certain the lever sleeve (f) is rotated to
properly mate with the outside lever/knob.
I-2 Insert one of the supplied keys (a) into the
outside lever/knob (b) and rotate key
counterclockwise 45 degrees.
I-3 Insert the outside lever/knob (b) until it is flush to the
outside unit assembly (levers fit closer than knobs).
Secure the outside lever/knob by rotating the key
clockwise 45 degrees to the horizontal position. Remove key.
Note: To remove the outside lever/knob from
the outside unit assembly, follow steps below.
I-4 Insert one of the supplied keys (a)
into the outside lever/knob and
rotate it counterclockwise 45
degrees. Insert the release tool (d)
into the small hole (e) under the
lever/knob as shown. Gently push
the lever catch up until it clicks.
Remove tool, then remove the
outside lever/knob.
J. INSTALLING/REMOVING
OUTSIDE LEVER/KNOB
(Interchangeable/Removable Core Models)
Note: Installing levers/knobs to the unit assemblies before
mounting the unit assemblies, may ease initial installation.
J-1 Make certain the lever catch is up as shown (c). The
lever catch should be flush around the entire diameter
of the outside driver. Make certain the lever sleeve (f) is
rotated to properly mate with the outside lever/knob.
J-2 Insert the outside lever/knob (a) until it
is flush to the outside unit assembly (b)
(levers fit closer than knobs). Insert the
release tool (d) (or screw- driver) into
the outside lever/knob as shown, and
slide the lever catch down until it clicks.
Note : For all interchangeable/removable
cores except ASSA/Medeco/Yale, proceed
to section J-3. For ASSA/Medeco/Yale
cores, skip to section J-5.
c
Correct
Position
Incorrect
Position
a
b
45º
b
a
IC Lever Sleeve
LH RH
f
e
a
45º
d
d
e
a
b
b
d
d
a
a