Kaba SIMPLEX 5000 CYLINDRICAL, Руководство по установке

Страница: 17 / 24

17
Interior Combination Change
M-3 Unscrew special torx screw from inside housing
using supplied torx wrench. Enter your existing
combination, and depress and release the
“ENTER” button. Insert longer end of the same
torx wrench through the opening until it engages
with the mating part. Turn wrench counter-
clockwise (using minimal force) approximately 90
degrees, until it clicks. Return wrench to initial position.
Remove wrench and replace torx screw.
M-4 **This Step Is Very Important** Rotate lever/ knob (d)
once, and only once to clear the old combination; the latch
(e) will retract; release the lever/knob.
M-5 Press in your new combination (b) followed by the
ENTER button (c) and release.
M-6 Rotate the lever/knob (d) to verify that the latch (e) retracts
confirming the validity of the new combination (if you try the
old combination now, it should not work).
IMPORTANT: The “ENTER” button must be depressed and released after
entering the combination. The latch will not retract until the “ENTER”
button is depressed and released.
Caution: Check the operation of the latch by making sure that the
deadlatch (a) stops against the strike (b) as shown and does not slide into
the strike opening when the door is closed. If that situation occurs, then a
total lockout may occur. This will void our warranty of the complete lock
mechanism. If necessary, correct the door over-travel by using the rubber
bumpers as described in Section N (Installing Rubber Bumpers).
COMBINATION SETTING RECORD
Combination & ENTER Date
& ENTER
& ENTER
& ENTER
& ENTER
& ENTER
& ENTER
& ENTER
& ENTER