Kaba SIMPLEX 5000 CYLINDRICAL, Руководство по установке

Страница: 18 / 24

18
N. INSTALLING RUBBER BUMPERS
N-1 Close the door and apply pressure making sure
the deadlatch (a) rests on the strike plate (b) as
shown. Standing on the frame (door stop) side of
the door, check for gaps between the door and
the frame on the three sides of the frame (left,
right, and top).
N-2 Mark locations where the gaps are approximately
3
⁄
16
" (5 mm). Make sure these locations are free
from grease and dust. Peel the bumpers (c)
(supplied) from their protective backing without
touching the adhesive surface and stick them on
the marked locations.
Note: Allow 24 hours for adhesive to set before testing.
The door may be operated normally during this time.
O. HOW TO RESET A LOST OR
UNKNOWN COMBINATION
There is no way to determine a forgotten, unknown or lost combination from
the front or outside of the lock. However, it can be reset and recovered or
reset and changed to a new combination by following the steps in this section.
Warning: Since this procedure is of a technical nature, only technically trained
personnel in the lock and hardware field should undertake this operation. For
further assistance, call the Kaba Access Control technical support line at
800-849-TECH (8324) or 336-725-1331 between 8AM and 5PM Eastern
Standard Time, Monday through Friday (except holidays).
O-1 Removing Lock From Door
Remove both the outside unit assembly (a) and the
inside unit assembly (b). (Reverse procedures from
sections E and F of this manual.)
O-2 Removing Combination Chamber Assembly
Carefully remove the base plate of outside unit
assembly (a) by removing the 2 Phillips screws (one screw
may be found under an inspection sticker).
Remove the combination chamber assembly (b) from the
base plate by removing the 2 Phillips screws (c).
Remove the 3-sided dust cover (d) to fully
expose the chamber by removing 2 small
Phillips screws (e). (May be 1 screw (x) in
newer models)
a
b
c
b
a
e
d
(x)
c
a
Correct
Incorrect
a
b
b