Kaba Mas X-10, Руководство по установке

Страница: 8 / 20

6
Note: Be careful to keep the cut as straight as
possible. Remember the saw only cuts when
pushing. Trying to cut while pulling may pull
the handle off of the saw blade.
6� The inside and outside of the tubes must
be deburred after cutting� Use the stone
provided for this purpose� Make sure
there are no sharp edges on either tube
(inside and outside) that will damage the
cables� (See
Figure 8�)
7� Install the inner tube on the lock case� Feed the
cables through the outer tube and install the outer
tube on the lock case� Measure and mark the inner
tube to be 1/16 to 1/8 inch longer than the outer
tube� (See Figure 9�) Remove the inner tube and cut
by the same method as described in Step 5�
Warning: The end of the outer tube that is to be
discarded must be from the plain (unflared) end of
the tube. The end of the inner tube that is to be
discarded must also be from the plain (unnotched)
end of the tube.
InsTallaTIon of The loCK
1� Place the inner tube into the lock case tube retainer� Make sure the cutout in the
tube aligns with the cables and allows the tube to seat completely in the tube
retainer� (See Figure 10�)
2� Feed the cables through the outer tube
from the flared end. Seat the tube into
position on the tube retainer on the back
of the lock case� (See Figure 4�) Be
careful to keep the cables pulled taut
while seating the tube to avoid pinching
and damaging them�
3� Carefully guide the outer tube (keeping
it in place on the tube retainer) through
the container wall so the outer tube and
the cables are easily accessible at the
outside wall of the container, retracting
the bolt if necessary�
4� Loosely attach the lock case to the container wall using the lock case
mounting screws�
5. Tighten the lock case mounting screws to the specified torque on page 1.
(Also see Figure 5�)
figure 9 - Inner and
outer
Tubes
figure 10 - seat Inner Tube
in retainer
figure 8 - deburr Tubes