Kaba Mas X-10, Руководство по установке

Страница: 10 / 20

8
InsTallaTIon of generaTor Cable and Cable guIdes
1� Place the generator cable into the dial ring housing recess containing a post
used for positioning the cable� (See diagrams in Appendix B�) The hole in the
cable must be positioned over the post on the dial ring, and the five gold tabs
must be visible�
2� The Zebra connector and Zebra connector housing are assembled at the factory
but may come apart during shipment� If so, insert the Zebra connector into the
Zebra connector housing before proceeding�
CAUTION: The Zebra connector is an electrical
connector. Keep it clean!
3� Place the Zebra connector and connector
housing over the generator cable, and press
it into the recess� The hole in the Zebra
connector housing must be positioned over
the post in the dial ring� Be sure the black
Zebra connector housing is positioned as
shown in Figure 14�
4� Install at least one of the stick-on cable
guides in an appropriate position to restrain
the cables� (See Figure 15 for possible locations�)
5� Route the cables through the cable guide that was just installed�
figure 13 - lCd and ZIf Connectors
figure 14 - Zebra assembly