5
figure 2 - Change Key
X-10 loCK seTUP
Setting up the X-10 lock for operation involves selecting both the operating mode and the
combination(s)
Note: The lock is shipped preset to operate in the Single Combination Mode with a
factory combination of 50-25-50.
Before you can set a new combination, you must select and set a mode of operation The
X-10 has three modes of operation:
single Combination Mode: The X-10 will open when one three-number combination
is successfully dialed
dual Combination Mode: Two separate combinations are required to open the X-10
Either combination may be dialed first; however, the operator must begin entering the
second combination within 40 seconds of completing the first combination.
supervisory/subordinate Mode or super/sub Mode: The Supervisory Combination
controls access of the Subordinate Combination The Supervisory Combination must
be entered first to Unlock (Ul) the lock Once the Supervisory Combination has been
entered, the Subordinate Combination can be used to open the lock at any time during
this “unlocked” state The Supervisory Combination can be entered again to disable
lock access - lock Up (lU) In this state the Subordinate Combination will no longer
open the lock
seT oPeraTIng Mode and Change CoMbInaTIons
Use the Change Key (See Figure 2) provided with your X-10 to set the desired operating
mode and combinations If at any time during the process you see the Key and Lightning
Bolt symbols displayed, stop the sequence and return to Step 4 If at any time after you start
the change key process you see only a Lightning Bolt symbol displayed, stop the sequence,
reinsert the change key, and return to Step 4
Note: The lock serial number may be used to complete this process if the current
combination has been lost or forgotten and if you can gain access to the back of the lock.
See next section “Using the Serial Number to Set Operating Mode and Combination.”
If you have not read the section on “Dialing the X-10” and “Opening the X-10 (Factory
Combination)”, it is important that you do so before proceeding�
Note: Use the preset factory combination of 50-25-50 to open the lock the first time. If
the container is already open, you may skip Step 1.
1 Open the lock by dialing the current combination(s) and retracting the bolt Then
remove the container dust cover to gain access to the change key holes on the back
of the lock
