T/SED900/016A
22
nd
August 2018
Installation Instructions for Panic or Emergency Latch with SBL339/SP
Digital Mechanical Lock
Installation
Correctly position and tape the template (T/SED900/023) for Panic or Emergency Latch, to the
internal door face, at the correct height from the floor level.
Mark the 4 pilot holes for fixing the Latch Unit.
Mark the 19mm diameter hole for the spindle of the Digital Lock
Mark the two 8mm holes for bolt through fixings and cup washers to secure the Digital
Mechanical Lock.
If fixing to Rebated Double Doors mark hole positioning for Universal Strike on the Inactive Leaf.
Drill all marked holes.
Setting/Changing the Code
On the reverse of the Digital Lock Unit you will see slotted buttons which
correspond to the push buttons on the front of the Lock.
To set a button to operate within the code turn the slotted button relating to
the number so that the dot is facing outwards (towards the ‘G’)
To take a button out the code turn the slotted button so the dot is facing
inward (towards the ‘F’)
Check the code on the Lock functions before fitting to the door.
IMPORTANT: Always press the ‘C’ button before inputting the programmed code
Handing the Digital Keypad
For Left-handed use
Positioning of Adapter in Follower
For Left handed applications the adapter should be positioned in the
follower of the Latch Unit as shown in Figure 4
For Right handed applications the adapter should be positioned in the
follower of the Latch unit as shown in Figure 4b
Figure 4b
Figure 4
For Right-handed use
After removing the Grub Screw; lift
and rotate the lever handle 180
degrees anti-clockwise. Relocate
the grub screw and tighten to
secure lever handle
Locate the Grub Screw in the
Lever Handle unscrew and
remove it using the supplied
Allen Key.
Locate the Grub Screw in the
Lever Handle unscrew and
remove it using the supplied
Allen Key.
After removing the Grub Screw; lift
and rotate the lever handle 180
degrees clockwise. Relocate the
grub screw and tighten to secure
lever handle
