4
oPen and Close The X-10
(factory Combination)
If you have not read the section on “Dialing the X-10”, it is important that you do so
before proceeding�
Note: The lock is shipped preset to operate in the Single Combination Mode with a
Default Factory Combination of 50-25-50.
TO OPEN THE LOCK (using the Factory Combination):
CW=ClockWise; CCW=CounterClockWise
1 Dial left (CCW) until lock is “powered” The lock is considered “powered” when
numbers appear on the LCD display screen
2 Continue dialing left (CCW) to the first number of the factory combination (50)Stop
on 50 and pause briefly
3 Dial right (CW) to the second number of the factory combination (25) Stop on 25 and
pause briefly
4 Dial left (CCW) to the third number in the factory combination (50) Stop on 50 and
pause briefly
5 Dial right (CW) After OP with a right arrow (OPen right) is displayed, continue dialing
to the right to retract the lock bolt
Note: If at any time the dial remains stationary for more than 40 seconds, the lock will
power down (LCD will go blank), requiring the operator to redial the entire combination.
TO CLOSE THE LOCK:
1 Turn Dial to the left (CCW) a minimum of one complete revolution to extend the bolt
and wait 3 seconds
2 Turn Dial to the right (CW) a minimum of one complete revolution to ensure that it is
locked
Note: The Dial should turn freely in either direction without catching or binding when
the bolt is extended and the lock is closed.
Practice opening and closing the lock several times with the preset factory combination before
you set a new combination When you feel comfortable opening the X-10 using the preset
factory combination, you are ready to put the lock into operation
