31
Servicing the Controller
The controller should always be serviced by an authorised agent.
Follow these simple steps to return the unit:
1
. Turn the mains power OFF to the controller.
Note:
If the controller is hardwired, a qualified electrician will be required to
remove the entire unit depending on the fault.
“IF NOT HARDWIRED - PROCEED TO 2”
2
. Disconnect the 24 VAC leads at the controller 24 VAC terminals on the very left
hand side of the terminal block.
3
. Clearly mark or identify all valve wires according to the terminals they are
connected to, (1–9). This allows you to easily wire them back to the controller,
maintaining your valve watering scheme.
4
. Disconnect valve wires from the terminal block.
5
. a) Remove the complete panel from the controller housing by unscrewing the two
screws in the lower corners of the fascia. (both ends of the terminal block)
b) Remove the complete controller from the wall unplugging the lead.
6
. Carefully wrap the panel or controller in protective wrapping and pack in a suitable
box and return to your service agent or the manufacturer.
Note:
Tampering with the unit will void the warranty.
7
. Replace your controller panel by reversing this procedure.
The controller should always be serviced by an authorised agent.
SERVICING THE CONTROLLER
MAC_RPS612_Instruction_Manual.indd 31
20/03/12 4:43 PM