JVC MC-8100U, Руководство по обслуживанию, Страница: 17 / 100

13
ENGLISH
3-5. Connecting the power cord and cables
Setup
CAUTION
Turn OFF the power of all equipment before starting connections.
Connecting the equipment while power is ON may lead to a malfunction.
• The allowable length for the SCSI cable inside the equipment is about 1.2 meters. In the case of SCSI-2 10
Mbytes/sec. sync operation, if the total length of the SCSI cabling including those cables outside the equipment
exceeds 3 meters, a malfunction may result. However, if the SCSI-2 5 Mbytes/sec. async mode is used the total
length of the SCSI cabling should be no more than 6 meters.
• Use a shielded SCSI cable with high-impedance specifications and be sure to attach the provided clamp filter to
the cable. Using other type of cable or using a cable without a clamp filter may cause radio wave interference and
a malfunction.
To SCSI-A
To SCSI port of
host computer
Attach the provided clamp filters.
To AC IN
To AC outlet
Attaching the clamp filters
Pull strongly.
Attach a clamp filter to the end of the cable.
Tighten until the tabs are
locked completely.
Push the clamp filter against the connector
and secure it by using the provided strap.
Cut any
surplus part.
Pull hard
Always use the power cord provided by JVC. The library system has been designed to conform to
“Insulation category Class 1”. In order to assure safety at all times, be sure to ground the system
before use. If other types of power cords other than the specified cord are used, they may overheat and
burn or cause a fire.
WARNING