JVC LST0728-001C, Инструкция по эксплуатации

Страница: 38 / 168

30
Basic Operation
Switching the Power On
1
Connect the power cable
●
Connect using the power cable supplied to an AC100V
(50 Hz/60 Hz) outlet.
2
Turn A ON B the power switch at the rear panel.
●
A system check will run when the power is turned on.
●
The [OPERATE] indicator starts blinking.
●
After blinking, the [OPERATE] indicator lights up to
indicate that operation has been turned on.
●
When the setting is complete, recording starts
automatically in the record control mode. (When the
A ON
at startup B checkbox of [Record Control] under [Unit
Setting 1] of the main menu is selected.)
Note :
●
Do not disconnect the power cord nor turn the power switch
A OFF B while the system check is running or in the OPERATE
ON mode. Otherwise, it may break down.
Memo :
●
If the device does not start up even after the power switch on the
rear panel is turned
A ON B , press the [OPERATE] button on the
front panel.
Switching the Power Off
1
Press and hold the [OPERATE] button for
about2 seconds to turn off the power
●
After blinking, the [OPERATE] indicator goes off.
2
Turn off the power switch on the rear panel
Note :
●
The recorded images may not be played back properly if they
are not archived (
A Page 110) before the power failure.
●
It is recommended that an uninterruptible power supply (UPS)
be used to protect the hard disk from damage in the event of a
power failure. (
A
Page 136)
●
Be sure to press and hold down the [OPERATE] button on the
front panel to shut down the system before switching off the
power supply. Turning off the power switch on the rear panel
while the device is in the OPERATE ON mode may cause
malfunction.
Switching On/Off Using Operate Button on
Front Panel
You can switch operation to ON or OFF.
䡵
Switching Operation On
1
(When Operation is OFF) Press the [OPERATE]
button
●
The [OPERATE] indicator starts blinking.
●
The [OPERATE] indicator lights up, indicating that
operation is enabled.
Memo :
●
When the power switch on the rear panel is turned on, the
system starts up automatically until the OPERATE ON mode is
activated.
䡵
Switching Operation Off
1
(When operation is ON) Press and hold the
[OPERATE] button for about 2 seconds
●
The [OPERATE] indicator starts blinking.
●
The screen display disappears and the [OPERATE]
indicator goes off, indicating that operation has been
turned off.
Note :
●
Do not turn off the power until operation has been turned off.
Switching On/Off Using Input/Output
Terminal on Rear Panel
For details on the layout of the input and output terminals on the
rear panel, refer to [Rear I/O Terminals] (
A Page 15).
䡵
Switching Operation On
1
(When operation is OFF) Set the [OPE ON/OFF]
terminal to make for at least 50 ms
●
The [OPERATE] indicator starts blinking.
●
The [OPERATE] indicator lights up, indicating that
operation is enabled.
䡵
Switching Operation Off
1
(When operation is OFF) Set the [OPE ON/OFF]
terminal to make for at least 1 s
●
The [OPERATE] indicator starts blinking.
●
The screen display disappears and the [OPERATE]
indicator goes off, indicating that operation has been
turned off.
Note :
●
Do not turn off the power until operation has been turned off.
Switching the Power On/
Off Switching Operation On/
Off