Settings
Settings
<Sound Effect>
Adjust the sound effect.
<Loudness>
Adjusts loudness.
•
OFF
(Initial)/
Low
/
High
<Bass Boost>
Selects the bass boost level.
•
OFF
(Initial)/
Level 1
/
Level 2
/
Level 3
/
Level 4
/
Level 5
<Volume Link EQ>
Reduces the driving noise by raising the bandwidth.
•
OFF
(Initial)/
ON
<Space Enhancement>
*1
Virtually enhances the sound space using the Digital
Signal Processor (DSP) system. Select the enhance
level.
•
OFF
(Initial)/
Small
/
Medium
/
Large
<K2>
*2
Restores the sound lost due to audio compression to a
realistic sound.
•
OFF
/
ON
(Initial)
<Sound Response>
Virtually makes the sound more realistic using the
Digital Signal Processor (DSP) system. Select the sound
level.
•
OFF
(Initial)/
Level 1
/
Level 2
/
Level 3
<Sound Lift>
Moves the center of the sound to the lower or higher
point. Select the height.
•
OFF
(Initial)/
Low
/
Middle
/
High
*1 You cannot change the setting when “Tuner” is selected as the
source.
*2 This function works only when “DISC”/ “USB”/ “iPod”/
“Android™” is selected as the source.
<Fader/Balance>
Touch
[
J
]
/
[
K
]
/
[
H
]
/
[
I
]
or drag the
mark to adjust.
<Fader>
Adjusts the front and rear speaker output balance.
When using a two-speaker system, set the fader to the
center (
0
).
•
F15
to
R15
(Initial:
0
)
<Balance>
Adjusts the left and right speaker output balance.
•
L15
to
R15
(Initial:
0
)
To clear the adjustment:
Touch
[Center]
.
<Speaker/X’over>
Preparation:
Before making the adjustment for
<Speaker/X'over>
,
select the appropriate crossover network mode
according to the speaker system (2-way speaker
system or 3-way speaker system).
1
Turn off the AV source.
On the Home screen, touch as follows:
2
Display the <X’over Network> screen.
On the monitor panel, press the following buttons
at the same time:
• For
KW-V140BT/KW-V240BT
:
and
EQ
• For
KW-V340BT
: and
3
Select the crossover network mode.
[2way]
Select this when 2-way system
speakers are used (front/rear).
[3way]
Select this when 3-way system
speakers are used (tweeter/mid
range/woofer).
A confirmation message appears. Touch
[Yes]
.
Setting the speakers and crossover
frequency
1
Select a car type (
1
), select the location
of the speakers (
2
)*, then display the
<Speaker Select> screen (
3
).
Car Setting
* Speaker location selection is available only when <X’over
Network> is set to [2way].
41
ENGLISH
EN̲KW-V2018ST̲KR.indb 41
EN̲KW-V2018ST̲KR.indb 41
2017/05/25 9:04
2017/05/25 9:04
