JVC KA-M790G, Инструкция по эксплуатации

Страница: 13 / 24

LEVEL
CALL
ON
INCOM
MIC
POWER
SELECT
RM
BATT.
OFF
E
F
G
J
H
I
BREAKER
Bottom
7
E
[INCOM MIC] Intercom Mic [ON/OFF]
Switch
ON/OFF switch for the intercom headset
microphone.
Set it to
A
ON
B
if the headset microphone is to be
used.
(
A
Page 13)
F
[INCOM LEVEL] Intercom Receiver
Volume
For adjusting the intercom headset receiver’s
volume level.
G
[CALL] Call Button
Press this button to send call signals to the
remote control unit operator without using the
intercom headset.
Pressing this button lights it up.
Call signals are sent to the remote control unit
while the button is pressed down.
(
A
Page 13)
H
[POWER SELECT] Power Selection
Switch
For selecting the power supply for the camera
(including this unit).
I
Tally Lamp
Lights up when call signals or tally signals are
received from the remote control unit.
(
A
Page 13)
J
[BREAKER] Breaker Button
The breaker switch will trip and cut off the power
if the power consumed is higher than the rated
capacity.
When power is cut off by the breaker, check for
any abnormality that may have caused the rated
power from being exceeded. If no abnormality is
found, press the [BREAKER] button to turn on
the power again.
If this unit does not function properly after turning on
the power, consult our authorized JVC dealers.
BATT. : Uses the [DC INPUT] terminal on
the camera or a battery.
RM : Uses the remote control unit
connected to the [RM] terminal
A
.
CALL : Blinks in red
TALLY (PGM) : Lit in red
TALLY (PVW) : Lit in green
KA-M790G.book Page 7 Friday, May 21, 2010 10:54 PM