JVC HR-DVS2EU, Инструкция по эксплуатации

Страница: 80 / 88

80
EN
CORRECTIVE ACTION
Position the camcorder so its
microphone is away from the TV.
Turn the TV’s volume down.
If you need the skipped channels,
restore them (
pg. 70).
Press PAUSE to pause the recording,
change channels, then press PLAY to
resume recording.
Perform manual setting again.
Turn off the recorder once and connect
the TV aerial cable to the recorder
properly, then turn on the recorder
again. The recorder will try Auto Set
Up again (
pg. 6).
Turn off the recorder once and connect
the fully-wired 21-pin SCART cable to
the recorder properly, then turn on the
recorder again. Then perform Preset
Download again (
pg. 8).
Re-set the remote control to the
correct brand (
pg. 43, 44).
Turn off the recorder or the con-
nected appliance once, then turn it
on again.
SYMPTOM
1. Whistling or howling is heard from
the TV during camcorder record-
ing.
2. When scanning channels, some of
them are skipped over.
3. The channel cannot be changed.
4. Channel settings that were made
manually seem to have changed or
disappeared.
5. No channels are stored in the
recorder's memory.
6. The remote control won’t operate
the TV or satellite receiver.
7. No picture appears when you
connect an appliance to DV IN/
OUT connector.
POSSIBLE CAUSE
●
The camcorder’s microphone is too
close to the TV.
●
The TV’s volume is too high.
●
Those channels have been desig-
nated to be skipped.
●
Recording is in progress.
●
After the manual settings were
made, Auto Channel Set was
performed.
●
The TV aerial cable was not
connected to the recorder when
Auto Set Up was performed.
●
The fully-wired 21-pin SCART cable
was not connected between TV and
the recorder when Preset Download
was performed.
●
The remote control brand setting is
incorrect.
OTHER PROBLEMS
TROUBLESHOOTING(cont.)