JVC GR-DVM5, Инструкция по эксплуатации

Страница: 63 / 92

EN
63
OFF
P
L
A
Y
A
M
5S
T W
Digital Dubbing
It is also possible to copy recorded scenes from the camcorder onto other video unit equipped with a DV
connector. Since a digital signal is sent, there is little if any image or sound deterioration.
NOTES:
●
You cannot use the battery pack installed in the
camcorder as the power supply since a digital signal is
output/input from/to the DV OUT/IN connector only
when using the AC Charger Station.
●
If the remote control is used when both the player and
recorder are JVC video units, both units will perform the
same operation. To prevent this from happening, press
the buttons on both units.
●
For Digital Dubbing, this camcorder can be connected
only to one device at a time. This camcorder can also be
used as a recorder.
●
If a blank portion is played back during dubbing, an
unusual image may be dubbed.
●
Even though the DV cable is connected correctly,
sometimes the image may not appear in step 3. If the
above occurs, turn off power and make connections
again.
1
●
The image with Digital Zoom, Fade/Wipe Effects, P.AE/
Effects and Snapshot is not output from the DV OUT/IN
connector. Only the original playback image is output
from it.
1 CONFIRM POWER-OFF STATUS
Make sure the camcorder's power is off.
2 MAKE CONNECTIONS
Attach the camcorder to the AC Charger
Station referring to step 2 as shown in the
illustration on pg. 58.
Connect the camcorder to your video unit
equipped with a DV connector using the DV
cable (optional) as shown in the illustration.
3
START PLAYBACK
Press the Play button (
4
) to play back the
source tape.
4 START RECORDING
While watching the playback on the monitor,
engage the DV connector-equipped video
unit's record mode from the spot on the source
tape you want to begin recording.
Video unit equipped
with DV connector
To DV OUT/IN
connector To DV OUT/IN
connector
DV cable (optional)
PLAY
STOP
To AC outlet
To use this camcorder as a recorder . . .
1. Select the recording mode (
Z
pg. 15).
2. Turn the Power Dial to “PLAY” while pressing down the lock button located on it.
3. Connect the DV cable as shown in the illustration and load a cassette to record on.
4. Press the START/STOP button to engage the Record-Pause mode. “DV IN” appears on the screen.
5. Press the START/STOP button to start recording. “DV IN” changes to “
DV IN
”.
6. Press the START/STOP button again to engage the Record-Pause mode. “
DV IN
” returns to “DV IN”.
Connector is
under the cover.
Lock!
START/STOP button