JVC DT-V21G11Z, Инструкция по эксплуатации

Страница: 20 / 32

20
Setting the menu (cont.)
REMOTE SETTING
(
☞
“External Control” on pages 22)
Settings for the external control.
Item Content Setting value
SERIAL TYPE Select the input terminal used for external control by serial
communication. RS232C
RS485
PARALLEL TYPE Select the external control method for the MAKE/TRIGGER terminal. MAKE, TRIGGER, SET
PIN1
PIN2
PIN3
PIN4
PIN5 Assign the control functions to the pins of the MAKE/TRIGGER terminal.
• Assign a function to each pin terminal by selecting “SET” in “PARALLEL
TYPE” mentioned above.
☞
<Functions controlled by the
MAKE/TRIGGER system> on page
23.
PIN6
PIN7
PIN8 The functions are assigned for “PIN6” – “PIN8” and you cannot change the
assignment of these functions.
☞
“Using the MAKE/TRIGGER
system” on page 22
CONTROL LOCK
Setting value: OFF, VOL.LOCK, ALL LOCK
Settings for disabling the buttons on the front panel.
●
The following operations are not available when “VOL.LOCK” is selected.
– VOLUME adjustment knob
– Picture adjustment knob
●
The “ALL LOCK” function disables to control the buttons on the front panel. But following operations are available.
– Turning on/off (on standby) the monitor.
– Press the button and button to display the SET-UP MENU, and set “CONTROL LOCK” to “OFF.”
– Operate this product by external control.
When you perform operations other than the above, “ Control lock on!” appears.
DVI INPUT SEL.
Setting value: AUTO, COMPO., RGB, PC
Settings for formats of signals input into the DVI-D (HDCP) terminal.
●
Automatically distinguishes signals when set to “AUTO.” (Normally, select “AUTO”)
●
Select “COMPO.”, “RGB” or “PC” when the picture is not displayed correctly with “AUTO.”
● DVI-D input of the monitor is compatible with HDCP.
SDI FORMAT
Setting value: AUTO, MS1YCbCr, MS2YCbCr, MS3YCbCr, MS4YCbCr, MS2 RGB, MS3 RGB, 3G-B-I
When “AUTO” is selected, 3G SDI/HD-SDI DUAL LINK signals are automatically recognized. (Normally select “AUTO.”)
● If the picture is unstable with “AUTO”, select the setting value according to the input signal format.
● “M” is displayed on the status display when a setting other than “AUTO” is selected.
DTV21G11̲LCT2681.indb 20 DTV21G11̲LCT2681.indb 20 12.2.5 10:17:05 AM 12.2.5 10:17:05 AM