18
Setting the menu (cont.)
SET-UP MENU
FUNCTION SETTING
Configure the sub menu display, the lighting color of the tally lamp, the size of images, the brightness of the button lamps.
Item
Content
Setting value
sub menu POSI.
Select the contents and displaying position of
“
sub menu.
”
The setting values and features are as follows.
LOWER1 :
Displays the current setting and adjustment bar at the lower part of the
screen.
UPPER1
:
Displays the current setting and adjustment bar at the upper part of the
screen.
LOWER2 :
Displays the current setting at the lower part of the screen.
UPPER2
:
Displays the current setting at the upper part of the screen.
•
The adjustment bar is not displayed for some items.
LOWER1
UPPER1
LOWER2
UPPER2
COLOR SYSTEM
Select the color system.
•
If the picture is unstable with “AUTO,” select “NTSC” or “PAL.”
AUTO, NTSC, PAL
COMPONENT PHASE
Deactivates the function of PHASE adjustment (Picture adjustment knob and “PICTURE SUB
ADJ.” in SET-UP MENU) except when an NTSC signal comes in (
☞
3
on page 9, page 19).
ENABLE, DISABLE
TALLY SELECT
Select the color of the tally lamp.
GREEN, RED
DIMMER
Select the intensity of the button lamps.
NORMAL, DARK
LCD SAVER
Set for reducing the burden on the LCD panel when it is used for a long time.
EXECUTE
Activate the function of the LCD SAVER.
SETTING
1st START
Set the Standby time.
00h-24h
WORK TIME
Set the time for operating the function.
01h-06h
CONTRAST
Set the reduction of the picture contrast.
SAVE, NORMAL
BACKLIGHT
Set the reduction of the BACKLIGHT brightness.
SAVE, NORMAL
OSD CONT.
Set the reduction of the OSD display contrast.
SAVE, NORMAL
SIDE MASK
Set use or nonuse of the side panel.
* The "SIDE MASK" function can operate irrespective of running/cancelling the LCD SAVER
function.
OFF, ON
reset
Reset the LCD SAVER SETTING configuration to the status when it was initially purchased.
CANCEL
Cancel the LCD SAVER function. ("CANCEL" will not be displayed during the function stop.)
STATUS
Display the LCD SAVER function status.
OFF, READY
START AFTER
Display required time until the LCD SAVER operation starts.
**h**min.
●
How to use the LCD SAVER
1. Set reduced function to perform.
2. Set both time for starting the function and time for letting it work.
3. Activate the STANDBY MODE by EXECUTE.
■
Aborting the ongoing function operation
Operating this apparatus may lead to aborting the OPERATION MODE.
■
Stopping the operation
Executing "CANCEL". Turn off the power.
●
Once operating the function, unless turned off the power or executed "CANCEL", reduced function is automatically performed
every 24 hours.
■
Example of setting up "1st START" and "WORK TIME"
0h
2h
4h
6h
8h
10h
12h
14h
16h
18h
20h
22h
24h
LCD SAVER in
Standby
Time to set in
the 1st START
Timing to run "EXECUTE"
LCD SAVER in
Standby
LCD SAVER in
Operation
Time to set in
WORK TIME
DTV21G11̲LCT2681.indb 18
DTV21G11̲LCT2681.indb 18
12.2.5 10:17:02 AM
12.2.5 10:17:02 AM
