JVC DT-F9L5, Инструкция по эксплуатации

Страница: 36 / 56

36 36
Menu Configuration (cont.)
Scope Setting*
1
Configure the settings for the wave form monitor and vector scope.
Item To do Setting value
Gain*
2
Adjust the input gain level. –10 to +10
Size* 3 Set the window size. Normal, Large
Position Select the window position. Lower Right, Lower Left
Upper Left, Upper Right
Transparent Activates/deactivates the function to make the window translucent. Off
On
Off
On :
: Normal
Translucent
Auto Off Set the function to turn off the window automatically 15 minutes after displayed. Off, On
Histogram Display Select the signal component for the histogram display. Y, R, G, B, RGB *
4
Wave Display Select a wave form to be displayed for the wave form monitor. Y, Pb, Pr (HD signal)
Y, Cb, Cr (SD signal)
R, G, B (RGB signal)
Wave Filter Turn on/off the lowpass filter to put over the input wave form data. Flat (No filter)
Lowpass
Wave Over Level Marking Turn on/off the function to change the wave form color of signals over the value specified in
“Wave Over Level”. (
☞
below)
Off, On
Wave Over Level Adjust the lower limit for the over level. 70 – 109
<Example of the histogram display> <Example of the wave form monitor> <Example of the vector scope>
Start End
Red White
Y
Image signals
The start and the end of the gradient
correspond to 0% and 100% of the signal.
(DT-F9L5 only) Ex.: When the luminance signal is Y, “Wave Over
Level Marking” is set to “On” and “Wave Over
Level” is set to “80”
• The wave form color of signals over the value
specified in “Wave Over Level” turns red.
• The display differs depending on the input
signal or the “Wave Display” setting.
Ex.: When the color bar is displayed
*
1
The vector scope is not displayed when the input signals are RGB.
*
2
Unavailable for the histogram.
*
3
Only “Normal” is available for the histogram. (DT-V9L5 only)
*
4
DT-F9L5 only.
Sync Function
Settings for the synchronization with signals.
Item To do Setting value
No Sync Action Select the screen status when no signal is coming in. Off, Standby, Power Save
(power save mode),
Gray Back (gray screen)
Delay Time Select the period until the screen status changes as selected in “No Sync Action” after signals
stop coming in. 30s, 5min, 15min
Low Latency Activates/deactivates the function to shorten the time taken to display the picture (low
latency function). Off, On
• If the picture is not displayed steadily while “On” is selected, select “Off.”
• While “On” is selected, the displayed picture may become unstable when an operation
using buttons on the front panel or the menu is performed, or when the signal format
changes.
●
When setting “No Sync Action” to “Gray Back,” the screen color changes to gray and the power consumption of the backlight is saved by half.
Selecting “Power Save” (power save mode) saves more power consumption by turning off the backlight.
Pixels
< dark light > brightness
DT-F9L5̲EU.indb 36 DT-F9L5̲EU.indb 36 2012/12/18 14:13:07 2012/12/18 14:13:07