0845 1204582
www.justkampers.com
JK part numbers:
J20264
OEM part number:
Not applicable
Just Kampers, Unit 1 Stapeley Manor, Long Lane, Odiham, Hants. RG29 1JE
NB. Please note that whilst every attempt is made to ensure that these instructions are as
accurate and clear as possible, we cannot be held responsible for misinterpretation of these
instructions or for any subsequent accident or damage caused through mis-fitted parts.
Tech Sheet
Spot Colour Pantone 653
Spot Colour P653/P151
Spot Colour White out
4 Colour Blue
4 Colour White out
4 Colour Blue/Orange
Black
White
Spot Colours
Process Colours
Page 5 of 7
12. Assemble awning pole, push through
pocket on awning and clamp to vehicle gutter.
13. The completed awning with sun canopies extended!
12. To the rear of the awning position your
vehicle 2ft (60cms) from the edge of the legs.
Unpack the three small diameter poles that
make up the awning pole and assemble.
Push this through the pocket on the leading
edge of the awning tunnel and place in your
vehicle gutter using three gutter clamps to
secure this in place. (Alternatively use a figure
of 8 or awning rail).
Pull the two elasticated end panels into place
and peg down the elasticated loops on each
corner.
13. Finally, if you wish to make use of the sun
canopies, do the following;
Unzip the sides of the flysheet.
Extend the sun canopy poles and twist to lock.
Insert the pin ends of the poles through the
holes in the corners of the awning side panel.
Loop the guy ropes over the pins and tension
the guys diagonally so that the canopy is taut
and able to support itself.
11. Before proceeding, make sure the awning
doors are zipped shut.
Unzip from the storage pouch and peg out the
two guy ropes on each outer leg diagonally
from the awning corner.
Peg out the remaining elasticated pegging
hoops.
11. Place awning end down with poles facing up.
