Juniper STRM 2500, Руководство по установке оборудования

Страница: 46 / 52

STRM Series II Hardware Installation Guide
38
R
ACK
-M
OUNTING THE
STRM S
ERIES
II A
PPLIANCE
Front-Rear-
Mounting
Recessed in Rack
This option provides additional front clearance in the equipment rack. It is used for
larger chassis, like the STRM 5000 II appliance, that requires additional support
when mounted on the rack-mount system.
To mount the appliance using this option:
Step 1
Remove the rear screws on each side of the system’s front rails and the two small
screws towards the front of the chassis.
Step 2
Loosen the side rail screws of the chassis and slide the front rails of the system
backward, as far as they will move.
Step 3
Tighten the side rail screws. Insert the two small screws in the recessed holes on
the front rails and tighten.
Step 4
Slide the rear mount rail brackets into the backs of the front rails on either side of
the chassis and align with your rear equipment rack posts. Secure the rear mount
rail brackets to your equipment rack with 2 rack mount screws each. See
Figure 21 .
Step 5
Insert locking screws on the sides of the rear mount brackets to secure the front
and rear mounting brackets in place.
Step 6
Verify that the mounting screws on one side of the rack are aligned with the
mounting screws on the opposite side and that the appliance is level.
The recessed position allows network and console cables to be routed through the
sides of the equipment rack and throught the holes of the recessed front rails on
either side of the unit. This enables easy cable routing on the racks with limited
cable management.
Figure 21 Front-Rear-Mounting recessed in rack
g040408
Mounting bracket, positioned forward for recessed mounting.