Juniper STRM 2500, Руководство по установке оборудования

Страница: 44 / 52

STRM Series II Hardware Installation Guide
36
R
ACK
-M
OUNTING THE
STRM S
ERIES
II A
PPLIANCE
Figure 18 Front-Mounting flush to rack
Front-Mounting
Recessed in Rack
This option allows sites with no front-of-rack clearance to recess the STRM system
in the equipment rack.
To mount the appliance using this option:
Step 1
Remove the rear screws on each side of the system’s front rails and the two small
screws towards the front of the chassis.
Step 2
Loosen the side rail screws of the chassis and slide the front rails of the system
forward, as far as they will move. See Figure 19 .
Step 3
Tighten the side rail screws. Insert the two small screws in the recessed holes on
the front rails and tighten.
Step 4
Insert 4 rack-mount screws on each side of the system to secure the chassis to the
rack-mount system.
Step 5
Verify that the mounting screws on one side of the rack are aligned with the
mounting screws on the opposite side and that the appliance is level.
The recessed position allows network and console cables to be routed through the
sides of the equipment rack and throught the holes of the recessed front rails on
either side of the unit. This enables easy cable routing on the racks with limited
cable management.
g040407