Juniper STRM 2500, Руководство по установке оборудования

Страница: 39 / 52

STRM Series II Hardware Installation Guide
A N
EW OR
C
HANGED
I
NFORMATION
This section describes the general known issues and limitations related to STRM
Series II appliances:
The recovery partition “Normal reboot” and “Factory Install” will not be
visible on a reboot of a STRM 5000 II appliance
This happens because the grub menus get wedged on the serial console grub
menu.
Workaround
: The next patch will have the fix for this issue. For now, you can Call
1-888-314-JTAC (from the United States,Canada, or Mexico) or 1-408-745-9500
(from elsewhere), for assistance on resolving the issue.
The eth0 port might not show link connectivity on STRM 5000 II appliance
even when eth0 is connected
This happens with the STRM 5000 II LAN ports after a clean installation of STRM
2009.1 only.
Workaround
: Run the STRMswap tool for the Ethernet ports.
Note:
This method should only be used on a STRM 5000 II appliance, fresh from
manufacturing if the eth0 or eth1 port does not come up even when there is
physical connectivity. The fix will be applied readily to all the new STRM 5000 II
appliances from manufacturing.
To run the STRMswap tool:
Step 1
Reimage the STRM 5000 II appliance with STRM 2009.1 USB. Boot the STRM
2009.1 OS after it is imaged.
Step 2
Download the tool STRMswap_eth.sh from https://www.juniper.net/support.
Step 3
Copy this script to a DOS USB stick (FAT32 formatted). Insert the USB stick with
script in the front USB port.
Step 4
Login as root.
Step 5
Enter
Ctrl-C
at the Unix prompt.
Step 6
Enter the following commands:
mount /dev/sdb1 /mnt