Juniper SSR1300, Руководство по оборудованию

Страница: 39 / 87

1. Wrap and fasten one end of the ESD wrist strap around your bare wrist, and connect the other end
of the strap to the ESD point on the appliance.
2. Ensure that the power supplies are fully inserted into the chassis.
3. Locate the AC power cords shipped with the SSR1300 appliance; the cords have plugs appropriate
for your geographical location. See
Table 7 on page 11 .
4. Pull the power cord retainer down and insert the coupler end of the power cord into the AC power
cord inlet on the AC power supply faceplate (see
Figure 14 on page 33 ) .
5. Push the power cord retainer onto the power cord (see Figure 14 on page 33 ).
Figure 14: Connect AC Power Cord
6. Repeat step 4 and step 5 to insert the second power cord.
7. If the AC power source outlet has a power switch, set it to the off (O) position.
8. Insert the power cord plug into an AC power source outlet.
9. If the AC power source outlet has a power switch, set it to the on (|) position.
10. Set the power switch on the appliance to the on (|) position.
Power Off the SSR1300
You can power off the SSR1300 in one of the following ways:
• Graceful shutdown—You can do a graceful shutdown in two ways:
• Use the Linux poweroff command at the Console. The appliance begins gracefully shutting down
the operating system and then powers itself off.
• Press and hold the power switch for less than 4 seconds. The appliance begins gracefully shutting
down the operating system and then powers itself off.
33