Juniper SRX1500, Руководство по оборудованию

Страница: 25 / 168

Table 3: SRX1500 Services Gateway Front Panel Components (continued)
Description Component Callout
Returns the services gateway to the factory-default configuration. Reset config
button 6
Indicate component and system status and troubleshooting
information at a glance. See
Table 4 on page 8 .
LEDs 7
Use the management (MGMT) port to connect to the device over
the network. Management
port 8
• Serial—Connects a laptop to the services gateway for CLI
management. The port uses an RJ-45 serial connection, is
configured as DTE, and supports the RS-232 (EIA-232) standard.
• USB—Connects a laptop to the services gateway for CLI
management through a USB interface. The port accepts a Mini-B
type USB cable plug. A USB cable with Mini-B and Type A USB
plugs is supplied with the services gateway. To use the mini-USB
console port, you must download a USB driver to the
management device from the
Silicon Labs
page.
Console port 9
The services gateway has one USB port that accepts a USB storage
device. USB port 10
Dedicated Gigabit Ethernet SFP port to synchronize data and
maintain state information in a chassis cluster setup. HA control port 11
For personal safety, while working on the services gateway, use
the ESD outlet to plug in an ESD grounding strap to prevent your
body from sending static charges to the services gateway. ESD point 12
NOTE: For information on supported transceivers, see the Hardware
Compatibility Tool .
Figure 2 on page 7 shows the SRX1500 Services Gateway LEDs.
Figure 2: SRX1500 Services Gateway Front Panel LEDs
Table 4 on page 8 lists the SRX1500 Services Gateway LEDs.
7 Copyright © 2017, Juniper Networks, Inc.
Chapter 2: Chassis Components and Descriptions