Juniper OCX1100, Руководство по оборудованию

Страница: 71 / 204

This topic describes:
•
Cable Specifications on page 51
•
Standards Supported by These Cables on page 53
Cable Specifications
OCX1100 switches support SFP+ passive direct attach cables. The passive Twinax cable
is a straight cable with no active electronic components. OCX1100 switches support cable
lengths of 3 ft (1 m) and 10 ft (3 m) long SFP+ passive direct attach cables.
Table 30 on page 51 describes the support for SFP+ passive direct attach cable lengths
on OCX1100 switches for Junos OS releases.
Table 30: Software Support for SFP+ Passive Direct Attach Cables for OCX1100 Switches
Cable Length Software Support Added Switch
3 ft (1 m) and 10 ft (3 m) Junos OS Release 14.1X53-D20 OCX1100-48SX-AFO
3 ft (1 m) and 10 ft (3 m) Junos OS Release 14.1X53-D20 OCX1100-48SX-AFI
3 ft (1 m) and 10 ft (3 m) Junos OS Release 14.1X53-D20 OCX1100-48SX-D-AFO
3 ft (1 m) and 10 ft (3 m) Junos OS Release 14.1X53-D20 OCX1100-48SX-D-AFI
NOTE: We recommend that you use only SFP+ direct attach cables purchased
from Juniper Networks with your Juniper Networks device.
CAUTION: If you face a problem running a Juniper Networks device that uses
a third-party optic or cable, the Juniper Networks Technical Assistance Center
(JTAC) can help you diagnose the source of the problem. Your JTAC engineer
might recommend that you check the third-party optic or cable and potentially
replace it with an equivalent Juniper Networks optic or cable that is qualified
for the device.
The cables are hot-removable and hot-insertable: You can remove and replace them
without powering off the switch or disrupting switch functions. A cable comprises a
low-voltage cable assembly that connects directly to two SFP+ ports, one at each end
of the cable. The cables use high-performance integrated duplex serial data links for
bidirectional communication and are designed for data rates of up to 10 Gbps.
Table 31 on page 52 describes the cable specifications.
51 Copyright © 2017, Juniper Networks, Inc.
Chapter 7: Transceiver and Cable Specifications