Juniper EX2200 Series, Руководство по оборудованию

Страница: 90 / 214

WARNING: When mounting an EX2200-C switch chassis in a vertical position,
orient the front panel of the chassis downward to ensure proper airflow and
meet safety requirements in the event of a fire.
NOTE: Do not block the vents on the top of the EX2200-C switches. Doing
this can lead to overheating of the switch chassis.
Before mounting the switch using magnet mount:
• Ensure that no rubber feet are installed on the bottom of the switch.
•
Verify that the site meets the requirements described in “Site Preparation Checklist
for EX2200 Switches” on page 41 .
• Place the desk in its permanent location, allowing adequate clearance for airflow and
maintenance, and secure it to the building structure.
•
Read “General Safety Guidelines and Warnings” on page 176 , with particular attention
to “Chassis and Component Lifting Guidelines” on page 181 .
• Remove the switch from the shipping carton (see “Unpacking an EX2200 Switch” on
page 67 ).
Ensure that you have the following parts and tools available:
• Magnet sheet (separately orderable)
•
Flat surface made of ferrous material
•
1 cable guard with 3 number-8 Phillips truss-head screws to secure the cable guard to
the EX2200-C switch (optional and separately orderable)
• 1 standard cable lock (optional and separately orderable) to secure the switch from
theft by connecting the cable to the security slots on the switch
1.
Mount the switch under a ferrous surface using magnet mount:
a.
Turn the chassis upside down.
b.
Place the magnet sheet on the bottom of the chassis.
NOTE: You can place the magnet sheet only at the bottom of the
switch.
Copyright © 2018, Juniper Networks, Inc. 90
EX2200 and EX2200-C Switches Hardware Guide