JUNIOR JONES J-Carbon, Инструкция по эксплуатации

Страница: 9 / 13

J-CARBON Instruction Manual
J-CARBON Instruction Manual
27 28
Attach your car seat by lower on to the adaptors (fig. 45).
To release the car seat adaptors twist the locking device round and lift
off (fig. 46).
CAUTION: always remove the car seat adaptors before folding the chassis.
The J-CARBON has been designed and tested for use with a variety of
leading brand car seats, for full details please visit the Support section
of our website; www.juniorjones.com or check with your local
experience centre.
WARNING:
only use car seats which have been approved by
JUNIORJONES.
20. Using the J-CARBON with a Carrycot
To assemble the carrycot, remove the apron and mattress to gain
access to the stay bars in the bottom of the carrycot.
Using the tabs, pull the stay bars into the clips on the baseboard until
you hear them click into place (fig. 47).
Replace the mattress and reattach the apron.
IMPORTANT: ensure that the stay bars are fully engaged before using
the carrycot.
Your J-CARBON carrycot comes with adaptors that are also compatible
with Group 0 Car Seats.
Slide the car seat adaptors into the housings on the chassis (fig. 48).
The car seat adaptors are labelled L and R. This is from the
perspective of you standing behind the chassis.
The adaptors will lock into place with a click.
WARNING:
ensure the car seat adaptors are locked in place
before use.
Attaching your carrycot by lowering it on to the adaptors (fig. 49).
To adjust the carrycot hood, depress the buttons on the side of the
hood (fig. 50) and pull up un til you hear it click into place.
Depress the buttons again to put the hood down.
To remove the carrycot, depress the release buttons on the side of the
carrycot (fig. 51) and lift upwards from the chassis and the adaptors.
To release the car seat adaptors twist the locking device round and lift
off (fig. 52).
CAUTION: always remove the car seat adaptors before folding the chassis.