Jungheinrich EJC B14, Руководство по эксплуатации

Страница: 55 / 107

03
.1
1
E
N
54
Z
If, after carrying out the following remedial action, the truck cannot be restored to
operation or if a fault in the electronics system is displayed with a corresponding
error code, contact the manufacturer’s service department.
Additional troubleshooting must only be performed by the manufacturer’s specialist
service engineers. The manufacturer's customer service department is specially
trained to carry out these operations.
In order for customer services to react quickly and specifically to the fault, the
following information is essential:
- Truck serial number
- Error number on the display unit (if applicable)
- Error description
- Current location of truck
5.1 Truck does not start
5.2 Load cannot be lifted
Possible Cause Action
– Emergency Disconnect (battery
connector) not plugged in.
– Key switch set to O.
– Battery charge too low.
– Faulty fuse.
– Check the Emergency Disconnect
(battery connector),
and plug it in if necessary.
– Set the key switch to “I”.
– Check the battery charge
and charge battery if necessary.
– Check the fuses.
Possible Cause Action
Truck not operational Carry out all measures listed under “Truck
does not start”
Hydraulic oil level too low Check the hydraulic oil level
Battery discharge monitor has switched
off Charge the battery
Faulty fuse Check fuses
Excessive load Note maximum capacity, see data plate
03
.1
1
E
N
54
Z
If, after carrying out the following remedial action, the truck cannot be restored to
operation or if a fault in the electronics system is displayed with a corresponding
error code, contact the manufacturer’s service department.
Additional troubleshooting must only be performed by the manufacturer’s specialist
service engineers. The manufacturer's customer service department is specially
trained to carry out these operations.
In order for customer services to react quickly and specifically to the fault, the
following information is essential:
- Truck serial number
- Error number on the display unit (if applicable)
- Error description
- Current location of truck
5.1 Truck does not start
5.2 Load cannot be lifted
Possible Cause Action
– Emergency Disconnect (battery
connector) not plugged in.
– Key switch set to O.
– Battery charge too low.
– Faulty fuse.
– Check the Emergency Disconnect
(battery connector),
and plug it in if necessary.
– Set the key switch to “I”.
– Check the battery charge
and charge battery if necessary.
– Check the fuses.
Possible Cause Action
Truck not operational Carry out all measures listed under “Truck
does not start”
Hydraulic oil level too low Check the hydraulic oil level
Battery discharge monitor has switched
off Charge the battery
Faulty fuse Check fuses
Excessive load Note maximum capacity, see data plate