Jungheinrich EJC B14, Руководство по эксплуатации

Страница: 54 / 107

53
03
.1
1
E
N
Long stroke = fast lift / lower
CAUTION!
X Release the button as soon as you reach the limit position of the load handler.
4.3.2 Transport the load unit.
Transporting load units
Requirements
– Load unit positioned correctly on the forks.
– Mast lowered for transport (approx. 500 mm above the ground).
– Good ground conditions.
Procedure
• Accelerate and decelerate gradually.
• Adapt your travel speed to the conditions of the route and the load you are
transporting.
• Travel at a constant speed.
• Watch out for other traffic at crossings and passageways.
• Always travel with a lookout at blind spots.
• On slopes and inclines always carry the load facing uphill, never approach at an
angle or turn.
4.3.3 Lowering the load unit
Depositing load units
NOTE
Loads must not be deposited on travel or escape routes, in front of safety
mechanisms or operating equipment that must be accessible at all times.
Requirements
– Warehouse location suitable for storing the load.
Procedure
• Drive carefully up to the storage location.
• Press the “Lower load handler” button (48).
• Carefully lower the load handler so that the forks are clear of the load.
• Carefully remove the forks from the pallet.
The load unit is lowered.
5 Troubleshooting
This chapter enables the user to identify and rectify basic faults and the effects of
incorrect operation. When trying to locate a fault, proceed in the order shown in the
table.
53
03
.1
1
E
N
Long stroke = fast lift / lower
CAUTION!
X Release the button as soon as you reach the limit position of the load handler.
4.3.2 Transport the load unit.
Transporting load units
Requirements
– Load unit positioned correctly on the forks.
– Mast lowered for transport (approx. 500 mm above the ground).
– Good ground conditions.
Procedure
• Accelerate and decelerate gradually.
• Adapt your travel speed to the conditions of the route and the load you are
transporting.
• Travel at a constant speed.
• Watch out for other traffic at crossings and passageways.
• Always travel with a lookout at blind spots.
• On slopes and inclines always carry the load facing uphill, never approach at an
angle or turn.
4.3.3 Lowering the load unit
Depositing load units
NOTE
Loads must not be deposited on travel or escape routes, in front of safety
mechanisms or operating equipment that must be accessible at all times.
Requirements
– Warehouse location suitable for storing the load.
Procedure
• Drive carefully up to the storage location.
• Press the “Lower load handler” button (48).
• Carefully lower the load handler so that the forks are clear of the load.
• Carefully remove the forks from the pallet.
The load unit is lowered.
5 Troubleshooting
This chapter enables the user to identify and rectify basic faults and the effects of
incorrect operation. When trying to locate a fault, proceed in the order shown in the
table.