eNet radio DALI gateway 1-gang mini
The status LED (3) flashes quickly for 5 seconds. The control unit is disconnected from
the radio transmitter. The control unit and radio transmitter exit the programming mode
automatically.
If there several connections or scene buttons for a radio transmitter, all connections must
be disconnected individually.
All On and All Off buttons of a radio transmitter are disconnected automatically as soon as
the last connection to the radio transmitter is disconnected. Manual disconnection is not
possible.
Resetting control unit to the default setting
All connections to radio transmitters are disconnected and parameters are reset to default set-
ting.
The connections in the radio transmitters are preserved and must be deleted separately.
Load is switched off.
￭
Press the Prog button for at least 20 seconds.
The status LED flashes after 4 seconds. After 20 seconds the status LED flashes faster.
￭
Release Prog button and press briefly once again within 10 seconds.
The status LED flashes more slowly for approx. 5 seconds.
Reset control unit to default setting.
Setting the minimum brightness
The minimum brightness can be set within a range of approx. 1...67 %, if, e.g. the light flickers
at low brightness or to compensate for differences in brightness.
￭
Switch on light.
￭
Turn operating mode switch (1) to the min. position.
The light switches to maximum brightness for approx. 2 seconds.
The light switches off and after approx. 2 seconds switches to the brightness that was last
set.
￭
Adjust brightness with the radio transmitter.
￭
Turn operating mode switch to the original position again.
When leaving the position min., the minimum brightness is saved. As confirmation, the
light switches to maximum brightness and switches to the set minimum brightness after
approx. 2 seconds.
Depending on the DALI ballast used, the signalling may vary from what is described here.
Save switch-on brightness
￭
Switch on light.
￭
Adjust brightness with the radio transmitter.
￭
Press button Prog (2) for longer than 4 seconds.
The light switches off briefly and then switches on again to the new switch-on brightness.
Switch-on brightness is saved.
Alternatively, the switch-on brightness can be saved with a radio transmitter, e.g. wall
transmitter.
6
Technical data
Rated voltage
AC 230 V~
Mains frequency
50 / 60 Hz
Power consumption
max. 2 W
Ambient temperature
-25 ... +70 °C
5 / 13
82580933
22.08.2019
J0082580933
