eNet radio DALI gateway 1-gang mini
Figure 3: Operating mode switch
Switch position
Function
PC
Operating mode, parameter set with eNet
server *)
DALI
DALI mode
min.
Setting of the minimum brightness
*)
If the operating mode switch is turned from the position PC, the operating mode and
parameters are set to the default setting. The settings made with the eNet Server will
be lost.
￭
Set the operating mode switch (1).
￭
Switch on mains voltage.
The ballasts can be switched by briefly pressing the Prog button.
Status-LED (3) lights up: switched on
Status LED (3) off: switched off
￭
Perform commissioning.
￭
Mount the cover.
5.2 Commissioning
The control unit can also be commissioned with eNet server as an alternative to the com-
missioning described here.
Connecting to radio transmitters
If several control units are switched in parallel, all radio transmitters will only connect to
one control unit.
Load is switched off.
￭
Press button Prog (2) for longer than 4 seconds.
The status LED (3) flashes after 4 seconds. The control unit is in programming mode for
approx. 1 minute.
￭
Switch radio transmitter to programming mode (see radio transmitter instructions).
￭
Trigger telegram on the radio transmitter.
The status LED lights up for 5 seconds.
The control unit is connected to the radio transmitter. The control unit and radio transmit-
ter exit the programming mode automatically.
If the status LED of the control unit flashes 3 times at 1-second intervals for
approx. 5 seconds, then the programming operation was not successful. All the memory
locations in the actuator or radio transmitter are occupied.
All On and All Off buttons of a radio transmitter are connected to the control unit automat-
ically as soon as the first connection to the radio transmitter takes place.
The scene buttons must be connected separately to the control unit.
Disconnecting connection to a radio transmitter
￭
Carry out the same steps as when connecting (see Connecting to radio transmitter).
4 / 13
82580933
22.08.2019
J0082580933
