JUMO 706521, Руководство по эксплуатации

Страница: 137 / 280

137
7 Configuration
Type; Additional storage
Selection "annual" or "total": the counter/integrator status is temporarily stored at the end of each month,
but not reset to 0. This means that the current status is always available for evaluation with the PCA3000
evaluation software at this point in time.
Time base "Integrator" function: The current measured value is integrated corresponding to the
selected time base, taking the factor into consideration:
Second The measured value is divided by 1 and
added up every second.
Minute The measured value is divided by 60 and
added up every second.
Hour The measured value is divided by 3600
and added up every second.
Day The measured value is divided by 86400
and added up every second.
"Operating time" function: The time base specifies the unit in which the operation
time is displayed:
Second Display in seconds
Minute Display in minutes
Hour Display in hours
Day Display in days
Threshold value "Integrator" function: Integration only takes place if the current measured value is
greater than the threshold value. The time base and factor are not included in the
threshold comparison.
-999999999 to
0 to +999999999 Threshold value
Reset signal The reset signal is used to set the counter and integrator statuses to 0 (inde-
pendently of other parameters). The current status is not saved in the process.
This reset signal is available in addition to the reset signal described in the previous
chapter "General settings".
Digital selector
The signal (high active) can be selected
from the list of digital signals.
No selection No signal selected.
Individual settings Instead of the general settings for the synchronization time, daily start, daily end,
period, and day of the week, it is also possible to use individual settings for each
counter/integrator.
Not activated (no checkmark)
The general settings are used.
Activated (checkmark) The individual settings are used (for "Pa-
rameter" and "Selection/settings": see
the previous chapter "General settings").
Parameter Selection/settings Description