EN
53
MAINTENANCE
WARNING!
The battery must not be mounted on the bike
during maintenance or repairs.
• Use a sponge moistened with a mild
detergent when cleaning. Do not use acidic
detergents, they can damage the bike.
• Avoid leaving the bike unprotected in the
rain or snow.
• If the bike gets wet, wipe it with a towel
after use.
• If the bike is used on a salted surface,
clean it after use with fresh water.
• Do not clean the bike with a high-pressure
washer – risk of water and moisture
penetrating into the electrical
components and motor.
BATTERY AND BATTERY CHARGER
• If the battery is not going to be used for
some time it should be kept charged to
about 50% (takes about 2–3 hours of
charging for a fully discharged battery) and
stored in a dry and well-ventilated place.
Failure to do this will invalidate the
warranty.
• Storage conditions for battery: temperature
–20 to +35°C, relative humidity 5 to 65%.
• Do not immerse the battery in water. When
transported the battery should be packed
in its original packaging and protected
from knocks and blows, vibration and direct
sunlight.
• Disconnect the charger from the battery for
storage.
CHAIN
Lubrication
The chain should be lubricated at regular
intervals with a suitable chain oil. Never let the
chain dry out. A dry chain wears more quickly,
becomes stiff and can start to rust. Replace a
damaged chain.
1. Clean any dirt off the chain.
2. Lubricate the chain.
3. Pedal a few turns so that the oil comes in
the links.
4. Wipe the chain with a cloth or sponge.
Chain tension
A chain that is not properly tensioned can
be dangerous. It should not be possible to
move the chain more than 1 cm “up or down”
at the mid point, but neither should it be
overtensioned.
1. Undo the nuts on the back wheel and pull
the back wheel backwards to stretch the
chain.
2. Tighten the nuts. Make sure the wheel is
fitted straight.
3. Check that the wheel is firmly in place.
HUB BEARINGS
Check for play in the hub bearings by holding
the rim of the wheel on the bike and moving it
from side to side. Adjust any play immediately,
otherwise there is a risk of damaging the hub
bearings and the wheel.
DISC BRAKES
The wire tension for the disc brakes is adjusted
with the adjuster screw on the respective brake
handles.
FIG. 12
GEARS
The gear wire tension is adjusted with the
adjuster screw on the hub of the back wheel.
FIG. 13
Содержание Kayoba 005025
