JUKI MO-6000S series, Руководство инженера

Страница: 21 / 94

−
17
−
Adjustment Procedures Results of Improper Adjustment
1) Loosen the setscrew of upper looper ball arm
3
and setscrew
5
of the upper looper holder.
2) Adjust the clearances between upper looper bracket
4
and
upper looper holder
1
to approximately 0.2 mm respectively,
and tighten setscrew
5
of the upper looper holder.
(Make sure that the upper looper holder smoothly moves
together with upper looper shaft
6
.)
3) Then determine dimension
F
from the bottom surface of the
frame to the top surface of upper looper holder pin
2
before
tightening the setscrew of upper looper ball arm
3
.
(Caution) Replace upper looper holder
1
according to the
needle gauge size.
™
Inaccurately positioned upper
l o o p e r h o l d e r w i l l c a u s e
excessive projection of the
upper looper, resulting in stitch
skipping, or other troubles.
(Caution) To adjust the upper
l o o p e r b a l l a r m , t a k e
dimension
F
as standard.
Remember that the projecting
amount and the height of the
u p p e r l o o p e r s h o u l d
e v e n t u a l l y b e p r o p e r l y
adjusted. So, confirm the
dimensions related to the
upper looper.