JUKI MO-6000S series, Руководство инженера

Страница: 17 / 94

−
13
−
Adjustment Procedures Results of Improper Adjustment
™
Excessive return of the lower
looper tends to cause stitch
skipping when filament thread is
used.
™ Insufficient return of the lower
looper tends to cause needle
thread stitch skipping when
spun thread is used.
™ Excessive clearance will often
cause needle thread stitch
skipping.
™ Insufficient clearance will cause
needle breakage due to the
contact of the looper with the
needle, or produce scratches on
the blade point of the looper,
l e a d i n g t o n e e d l e t h r e a d
breakage or other troubles.
1) Returning amount of the lower looper
1
Loosen setscrew
2
of lower looper support arm
1
and adjust
lower looper
4
to make adjustment of the returning amount.
(Referential information)
1. Radius
K
of lower looper
4
will be 66.9 mm when the lower
looper is inserted into lower looper support arm
1
until it
contacts with stopper pin
3
and then is fixed.
2. The rocking angle of the lower looper will be 26˚.
(MO-6 S, R)
The rocking angle of the lower looper will be 32˚.
(MO-69 G, J)
2) Clearance between the lower looper and the needle
MO-6700S Series
1
Loosen setscrew
2
of lower looper support arm
1
to the extent
that it is temporarily tightened. Now, make the adjustment by
moving lower looper support arm
1
back and forth.
MO-6900S, R, G, J Series.
1
Loosen setscrew
2
of lower looper support arm
1
to the extent
that it is temporarily tightened. Then finely adjust the longitudinal
position of the looper using fine adjustment screw
5
.
2
Turn fine adjustment screw
5
clockwise to move lower looper
4
away from the needle.
Turn the screw counterclockwise to move lower looper
4
closer
to it.