JUKI HZL-600, Инструкция по эксплуатации

Страница: 27 / 108

24
Fabric, thread and needle table
Fabric Thread Needle
HA×1
Light-weight
materials
Lawn
Silk thread
…………………………………………
No.80,90
Spun thread
………………………………………
No.80,90
No.11
Georgette
Tricot Spun thread
………………………………………
No.60-90
Knit needle
No.11
Wool and synthetic
fabrics
Silk thread
………………………………………………
No.80
Spun thread
……………………………………
No.60
-
90
No.11-14
Medium-weight
materials
Cotton and synthetic
fabrics
Spun thread
……………………………………
No.50
,
60 No.11-14
Light jersey
Silk thread
………………………………………………
No.50
Spun thread
……………………………………
No.50, 60
Knit needle
No.11
Ordinary wool and
synthetic fabrics
Silk thread
………………………………………………
No.50
Spun thread
……………………………………
No.50, 60
No.11-14
Heavy-weight
materials
Denim Spun thread
………………………………………
No.30-50 No.14-16
Jersey
Silk thread
………………………………………………
No.50
Spun thread
……………………………………
No.50, 60
Knit needle
No.11-14
Coat Silk thread
………………………………………………
No.50 No.11-14
* In general, the same thread is used for both needle and bobbin threads.
* Thin thread and needle will be used for light-weight fabrics and thick thread and needle will be used for
heavy-weight materials.
* Check that the combination of needle and thread is OK by trial sewing on the material which will be sewn.
* Knit needle is good for stretchy fabrics (such as knits) and synthetic fabrics.
* Use thread No. 30 - 90.
* When it is difficult to go over an overlapped section, guide the fabric by hand.
* When sewing decorative stitches or letters (Page 28, 30 and 32), use knit needle for better finish.
25
Needle size:
The larger the number, the thicker the needle.
23
Attaching the needle
Needles to be purchased
When purchasing spare needles,
specify HA X 1 (130/705H) or
HA X 1 SP (needle for knits) .
Checking the needle
Check the needle for its straightness occasionally.
Any bent needle would cause skipped stitches,
thread breakage or damage to materials.
Flat object
The flat part of the needle
Shank
Needle setscrew
Stopper pin
Hold the needle
with its flat part
facing away
from you
The machine will not sew if the needle is not inserted
correctly and/or a bent needle is used. It will cause
damage to the machine.
1
Removing needle
1. Turn the hand wheel towards you until the needle
comes to the highest position and lower the presser
foot.
2. Turn the needle setscrew towards you 1-2 times and
remove the needle.
2
Attaching the needle
(The needle cannot be inserted unless it
is correctly positioned.)
Hold the needle with its flat part facing away from you,
and insert it fully until it touches the stopper pin.
Securely tighten the needle setscrew.
Attention:
Screwdriver
Warning
Turn OFF the power switch
before changing the needle.