JUKI HZL-600, Инструкция по эксплуатации, Страница: 19 / 108

1
Place the thread spool to the spool
pin.
2
Winding the bobbin thread
16
* An exclusive motor is built-in for winding
bobbin so that you can wind bobbin at
any time.
Set the bobbin on the bobbin winding
shaft.
3
4
Wind the thread to the bobbin 4-5 times in
clockwise direction.
Put the thread end into the guide at the
bobbin winding shaft and pull it to the
right side to cut it.
5
7
Push the bobbin winding regulator
towards the bobbin to start winding the
bobbin.
* Be careful that the bobbin winding regulator
works as a switch.
6
When winding is finished, the shaft
stops automatically, the bobbin winding
regulator moves to right and return to the
original position.
Remove the bobbin from the bobbin
winding shaft and cut the thread by cutter.
* Bobbin winding will automatically stop even
while winding, when the winding speed is
reduced due to a load to the bobbin winding
motor caused by thread tangling.
Bobbin winding regulator
Guide (with cutter)
Cutter
Thread the guide
A
and then
thread the thread guide (guide in
the circle) for bobbin winding
Spool
pin
Thread guide
A
Bobbin
winding shaft
17
15
Bobbin thread preparation
Open the hook cover.
Take out the bobbin.
* If the bobbin has too little thread, do not use it as
the thread will get tangled.
* Use only the designated bobbin. Other bobbins may
cause malfunction.
1
2
Taking out the bobbin
1 Small spool
Large spool
Spool Cap
Spool Cap
Place a thread spool to spool pin and a
spool cap onto the spool pin.
* Do not use the thread cone with a small amount
of thread. This may cause thread tangling
and/or the thread coming out of the eye of the
needle when starting to sew.
There are three types of the spool caps, large, medium
and small. Choose the size of spool cap according to
the thread spool to be used.
Setting thread spool
Hook cover
Attention
Turn OFF the power switch
before the bobbin is taking
out and/or put into the
bobbin case.