I . SPECIFICATIONS
1) Sewing area
2) Max. sewing
3)
length
4) Feed motion of feeding frame
5) Needle bar stroke
6) Needle
7) Lift of feeding frame
8) Intermediate presser stroke
9) Lift of intermediate presser
10) Shuttle
11) Lubricating oil
12) Memory medium
13) Temporary stop facility
14) Enlarging Reducing facility
15) Enlarging/Reducing method
16) Max. sewing speed limitation
Pattern selection
Bobbin thread counter
Memory back-up
2nd
setting facility
Needle-up stop facility
23)
Sewing machine motor
Dimensions
24)
25)
27)
30)
Gross weight
Power consumption
Operating temperature range
Operating humidity range
Line voltage
Air pressure used
Air consumption
Needle highest
facility :
the
of sewing. the needle can be brought up
its highest
position.
: X
direction 130 mm
Y (longitudinal)
60 mm
: 2,500
(when sewing pitch is 3 mm or less)
: 0.1 to 12.7 mm (adjustable in 0.1 mm steps)
: Intermittent feed
by stepping motor)
: 41.2 mm
: DP 5, DP 17
: 25 mm (standard) Max. 30mm
: 4 mm (standard) (0.5 to 10 mm)
:
: Double-capacity
hook (self-lubricated)
: New Defrix Oil No. 2 (supplied by oiler)
: 3.5 inch micro floppy disk
2HD)
Memory pattern : 44 to 691 pattern cassette
: Used to stop machine operation during a stitching cycle.
: Allows a pattern to be enlarged or reduced on the X axis and Y axis
independently when sewing a pattern.
Scale : 0.01 to 4 times (0.001 steps)
: Pattern enlargement reduction can be done by increasing decreasing
either stitch length or the number of stitches.
: The maximum sewing speed can be set limited to any value within a
range of 200 to 2.500
using
external control knob.
: 1 to 999 patterns can be selected by specifying the desired pattern Nos.
: Tells the time to replace the bobbin.
:
case oi a power interruption, the pattern being used will
be stored
so that the interrupted sewing cycle may be resumed
simply by pressing the Set Ready switch after the power is
: Using jog keys, a 2nd origin (needle position after
cycle) can be
set in the desired position within the sewing area. The set 2nd origin is
also stored in memory.
: When the needle does not stop in its upper position, the needle can be
brought up to the upper position by turning again the needle threading
switch.
: 400W servo-motor
: 1,200 mm
710 mm (L) 1,200 mm (H)
(Excluding thread
: 120 kgs
: 600 VA
:
to
: 20% to 80% (No
condensation)
: Rated voltage
50 60 Hz
: 0.5 to 0.55
(5 to 5.5 kgf
: 1.8
For pneumatic type only.