6
H:\0 - Quality Documents\2 Department\Tech Serv\Application tooling\Presses\AP-K2N\TS010-00 AP-K2N Operation
Manual.doc
3. PREPARING FOR OPERATION
3.1 Mounting the Reel Hanger
Due to packing considerations, when you receive the
machine the reel hanger is not mounted on the machine.
Assemble the reel hanger then mount it on the machine
as illustrated below.
3.2 Mounting the applicator (All types)
Step 1
Loosen bolts A & B with a 5mm hexagon wrench
supplied with the tool-kit.
Step 2
Remove the protective rubber collar from under the dials
on the applicator ram.
Step 3
Place the applicator on the base-plate of the crimping
machine. Pull up the applicator ram whilst simultan-
eously pushing the feed lever in the direction of the
arrow shown in the photograph below, so that the collar
on the shank slides into the groove on the press ram.
Then push the applicator fully back into the press.
CAUTION
ENSURE THAT THE SHANK IS CORRECTLY
LOCATED IN THE RAM. THERE IS A DANGER OF
MAJOR TOOLING DAMAGE IF THE TOOLING IS NOT
LOCATED CORRECTLY (AS IN THE PHOTOGRAPH
BELOW).
Step 4
Securely fasten the clamps with the 5 mm hexagon key,
and visually check that the tooling is mounted correctly.