19
H:\0 - Quality Documents\2 Department\Tech Serv\Application tooling\Presses\AP-K2N\TS010-00 AP-K2N Operation
Manual.doc
7. CRIMPING MACHINE
MAINTENANCE
CAUTION
Disconnect the Power Cable from the mains
supply before carrying out any maintenance
operations on the Crimping Press.
7.1 Lubrication
MAIN SHAFT BEARING
Lightly grease the main-shaft bearing once a year using
a general purpose grease, eg Castrol LM.
RAM SECTION
Remove the cap head socket screws from the ram cover
and add a few drops of machine oil to the felt pads in the
three oiling holes once a week.
CLUTCH SECTION
Remove the cap head socket screws from the belt-cover
catch and open the cover.
Add a few drops of oil to the oiling points indicated on the
photograph.
NOTE: The frequency of lubrication is dependant on the
use of the machine. Do not apply excessive lubrication
because the oil may drip through onto the applicator
and contaminate the terminals.
ROLLER CLUTCH
Step 1
Slowly rotate the fly-wheel whilst pulling the V-belts to
the side to remove them.
CAUTION
ENSURE THAT FINGERS DO NOT BECOME
TRAPPED BETWEEN THE V-BELT AND THE
FLY-WHEEL
Step 2
With the aid of a pair of internal circlip pliers, remove the
circlip retaining the fly-wheel.
MAIN SHAFT BEARING GREASING LOCATION
RAM SECTION OILING LOCATIONS
CLUTCH SECTION OILING LOCATIONS