9
Work Stop
Referring to Figure 4.
A work-stop is provided with the machine to allow
cutting multiple pieces of identical length. The stop
consists of a set rod onto which is installed a distance
set bracket, stop rod assembly and two lock handles.
The rod is installed in a bore in the front of the saw bed.
The distance set bracket is moved in or out on the set
rod to establish the length of the work-piece and the
stop rod can be adjusted to accommodate work-pieces
of various widths.
Stand Assembly
Referring to Figure 5.
Tools required for assembly:
Two 13mm wrenches (
Note:
A ratchet wrench may
speed assembly time.)
1.
Assemble the
rear
(D
1
) and
right
side
(E
1
)
panels
with two M8 x 15
hex cap screws
(A), two 5/16”
flat
washers
(B) and two M8
hex nuts
(C). Tighten the
hex nuts.
2.
Assemble E
2
and D
2
in the same manner.
3.
Assemble the level pad (G) and hex nut (F) in stand.
4.
Finish assembling E
2
to D
1
and E
1
to D
2
in the same
manner as above.
Mounting Saw to Stand
Remove any plastic or holding straps from around the
band saw. Areas of the machine have been given a
protective coating at the factory. This should be
removed using a soft cloth moistened with kerosene or
a cleaner-degreaser. Do not use gasoline, paint thinner,
or lacquer thinner as these will damage painted
surfaces. Do not use an abrasive pad.
Determine the final location for the saw and allow for a
sufficient work space around it.
The saw is extremely heavy. Use a
hoist to lift.
When moving the saw/stand top
assembly the cutting head, or “bow”, should be in the
down position.
Fig. 4
Assembly (Fig 5)
Содержание JET MBS-708CSB
Страница 22: ...22 Replacement Parts Saw Table Assembly Drawing 1 of 3 Exploded View ...
Страница 23: ...23 Saw Bow Assembly Drawing 2 of 3 Exploded View ...
Страница 24: ...24 Saw Stand Assembly Drawing 3 of 3 Exploded View ...
Страница 30: ...30 Wiring Diagrams ...