JPW JET MBS-708CSB, Руководство по эксплуатации

Страница: 16 / 31

16
Adjusting Blade Tracking
Note: Before making any tracking adjustments, try a
new blade. Warped blades do not track well.
Blade tracking has been set at the factory and should
not require adjustment. If a tracking problem occurs,
adjust the machine as follows:
Refer to Fig 22 / 23.
1.
Move saw bow to proper height position and lock
in place by shutting off the hydraulic cylinder valve.
2. Confirm that blade tension is set properly. To
adjust, see section titled Adjusting Blade Tension.
3. Open back wheel cover by loosening lock screws.
4. Run saw and observe blade. Blade should run next
to but not tightly against wheel flange.
5. If need to adjust blade track, remove the screws of
cover (A, Fig. 22).
6. Loosen bolts (B, Fig. 23) a little bit.
7. Turn setscrew (C, Fig. 23) while observing blade
tracking on wheel. Turn setscrew (C) clockwise to
track blade closer to the wheel flange. Turn set
screw counter-clockwise to track blade away from
the wheel flange.
8. Once tracking is set, tighten bolts (B).
9. Recovery the cover (A).
Fig. 22
Fig. 23
Adjusting Bow Angle for miter cuts
Refer to Fig 24/25.
For miter cutting, it needs to swivel saw frame to
desired angle. The cutting angle for this machine is 0 ~
60° on the left side, 0~45° on the right side.
There is a bar (A) for frame to stop at zero position on
right side swiveling moving, if need to cut in the left side
that have to pull out the zero position lock bar (A) then
swivel frame to set desired angle at the left cutting.
Loosen the frame tighten lock handle (B) and wing nut
(D) at the other side before swiveling.
Swiveling saw frame and seat to desired angle which
indicated with angle scale (C). Then Tighten handle
screw and wing nut eventually.
Fig. 24
Fig. 25
When you doing the left side angle cutting (0 ~ -45). You
need to move the vise forward, in the meanwhile, take
the part to the back of the vise.
Refer to Fig. 26/27/28/29/30.
B
C
A
A
B
C
D