JPW JET MBS-708CSB, Руководство по эксплуатации

Страница: 13 / 31

13
Adjustments
Adjusting movable Blade Guide
Refer to Fig 13.
Red blade guard must be reinstalled
after new blade is fitted.
1. Disconnect machine from the power source.
2. Loosen lock handle A and knob B. Slide blade guide
assemblies as close as possible to the material for
cutting stably.
3. Tighten handle A and knob B after adjusting.
Fig.13
Vise Operation
Refer to Fig 14.
Do not make any adjustments or
load/unload material from vise while machine is
running! Failure to comply may cause serious injury!
The vise is mounted on the machine base. Follow the
easy steps to open or close the vise.
1.
Turn the hand wheel (A) Fig.14 counter clockwise
to open the vise jaw to allow the width of vise can
load work piece.
2. Make sure the work piece is well located on the
table. Turn the handle (A) clockwise to close the
vise jaw to clamp the work piece. Sure the work
piece is well located on the table. Turn the handle
(A) clockwise to close the vise jaw to clamp the
work piece.
Fig. 14
Adjusting Blade Tension
Refer to Fig 15.
Blade tension is important to the proper operation of
the saw. This saw proper blade tension is in 1500 to
1700kg/cm
2
as measured on blade tension gauge.
To set the blade tension without the use of a blade
tension gauge:
1. Disconnect machine power, open wheel covers to
install blade belt between wheels and insert blade
between bearings on blade guides.
2. Tension blade slightly to remove any sag in blade
between blade wheels.
3. Turn blade tension knob (A) clockwise to tighten
until the red line approach to central line (B).
4. After blade has been completely installed, close
wheel covers, connect to the power source, and
run saw for one minute so blade can seat properly.
Fig. 15
A
B
A
A
B