JPW JET MBS-708CSB, Руководство по эксплуатации

Страница: 10 / 31

10
Referring to Figure 6:
1. The saw (A) and stand top (B) come as an
assembled unit. Use a hoist to lift and place the saw
onto the
stand (C).
Note that the front of the saw faces the same
direction as the indented panel of the stand.
2. Adjust the stand top (B) and stand (C) so the corner
mounting holes (D) are aligned.
3. Secure the stand top (B) to the stand (C) with four
each M8 hex cap screws (E) with M8 flat washers
(F). Tighten with a 13mm hex wrench.
Install the extension trays
Refer to Fig 7.
Install the coolant collectors (R) at the left and right side
of the base.
Machine Base
Referring to Fig 8.
The base is a structure supporting the saw frame, the
vise, the bar stop, the work-piece supporter, coolant
pump, swing arm, and the coolant return plates. The
base house includes the cooling liquid tank.
Assembly (Fig 6)
Fig. 7
Fig. 8
Coolant System
Referring to Fig 9.
Oils for Lubricating Coolant
Considering the vast range of products on the market,
the user can choose the one most suited to their own
requirements, using as reference the type SHELL LUTEM
OIL ECO. THE MINIMUM PERCENTAGE OF OIL DILUTED
IN
WATER IS 10 - 20 %.
Cleaning the Tan
Use hex wrench to open the plug located on the rear
base below the pump. Allow the coolant to drain-out.
Remove the filter net (P) by loosening the four screws.
Remove the pump (Q) by loosening the four screws.
Use a vacuum cleaner to vacuum chips and debris from
the tank.
Replace the plug.
Thoroughly clean the pump (Q) and replace.
Fill the tank with coolant to approximately 25mm below
the filter net (P).
Clean and replace the filter net.
R
C