Joycare JC-1321, Руководство пользователя

Страница: 15 / 84

14 15
3. CONNECTING THE CUFF TO THE MONITOR
Insert the cuff tubing connector into the socket in the left side of the
monitor. Make certain that the connector is completely inserted to avoid
air leakage during blood pressure measurements.
Avoid compression or restriction of the connection tubing during
measurement, as this may cause an inflation error or harmful injury due to continuous cuff pressure.
4. APPLYING THE CUFF
a. If required, pull the cuff end through the medal loop (the cuff is packaged
like this already).
b. Place the cuff around a bare arm 1 to 2 cm above the elbow joint.
c. While sitting, place your hand with the palm facing up onto a flat surface
like a table or similar. Position the air tube in the middle of your arm in line
with your middle finger
d. Tighten the cuff and close the Velcro fastener. The cuff should fit
comfortably, yet snugly around your arm. You should be able to insert
one finger between your arm and the cuff.
Note:
Please refer to the cuff circumference range in “SPECIFICATIONS” to make sure that the appropriate cuff is used.
1. Measuring on same arm each time.
2. Do not move your arm, body, or the monitor and do not move the rubber tube during measurement.
3. Stay quiet, calm for 5 minutes before blood pressure measurement.
4. Please keep the cuff clean. If the cuff becomes dirty, remove it from the monitor and clear it by hand
in a mild detergent, then rinse it thoroughly in cold water. Never dry the cuff in clothes dryer or iron it.
Clean the cuff after the usage of every 200 times is recommended.
5. BODY POSTURE DURING MEASUREMENT
Sitting Comfortably Measurement
a. Be seated with your feet flat on the floor, and don’t cross your legs.
b. Place palm upside in front of you on a flat surface such as table.
c. The middle of the cuff should be at the level of the right atrium of the heart.
Lying Down Measurement
a. Lie on your back.
b. Place your arm straight along your side with your palm upside.
c. The cuff should be placed at the same level as your heart.
6. TAKING YOUR BLOOD PRESSURE READING
a. After applying the cuff and with your body in a comfortable position, press the “START” button. A
beep is heard and all display characters are shown for self test. See Fig. 6. Please contact the service
centre if a segment is missing.
b. Then the current user number is shown (U1 or U2) is flashing. See Fig. 6-1. Press the “MEM” button
to change to the other user. See Fig. 6-2. Confirm your selection by pressing the “START” button. The
current bank will also be confirmed automatically after 5 seconds with no operation.
6 6.1 6.2