5
137945_Rev_F 7.29.10
General Information
THIS HEATER MUST BE INSTALLED AND MAINTAINED
BY A QUALIFIED SERVICE AGENCY.
The installation and repair of this appliance must be
done by a qualified service person. Failure to properly
install and maintain this heater could result in an
unsafe or hazardous installation, which may result in
a fire, explosion, property damage, personal injury or
loss of life.
This appliance may be installed in an aftermarket
permanently located, manufactured (mobile) home,
where not prohibited by local codes.
This appliance is only for use with the type(s) of gas
indicated on the rating plate. This appliance is not
convertible for use with other gases, unless a certified
kit is used.
Cet appareil peut être installé dans un maison préfab-
riquée (mobile) déjà installée à demeure si les règle-
ments locaux le permettent.
Cet appareil doit être utilisé uniquement avec les
types de gas indiqués sur la plaque signalétique. Ne
pas l’utiliser ave d’autres gas sauf si un kitde conver-
sion certifié est installé.
This appliance should be inspected before use and
at least annually. More frequent cleaning may be
required due to excessive lint from carpeting, bedding
material, etc. It is imperative that control compart-
ments, burners, and circulating air passageways of
the appliance be kept clean.
THIS APPLIANCE MUST NOT BE CONNECTED TO A
CHIMNEY OR FLUE SERVING ANY OTHER APPLIANCE.
The installation must conform to local codes. Your lo-
cal Jøtul dealer can assist you in determining what is
required in your area for a safe and legal installation.
Some areas require a permit to install a gas burning
appliance. Always consult your local building inspec-
tor, or authority having jurisdiction, to determine
what regulations apply in your area.
CODE COMPLIANCE: Your local officials have final
authority in determining if a proposed installation is
acceptable. Any requirement that is requested by the
local authority having jurisdiction, that is not specifi-
cally addressed in this manual, defaults to local code.
In the absence of local codes, the installation re-
quirements must comply with the current edition of
National codes. In the U.S., these requirements are es-
tablished in the National Fuel Code, ANSI Z223.1.(NFPA
54) current edition. In Canada, the codes have been
established in CAN/CGA B149 Fuel Installation Code,
current edition.
Glass Panel
Do not operate this appliance with the glass
front removed, cracked, or broken. Replacement
of the glass should be done by a licensed or
qualified service person. Only remove glass for
routine service. Always handle glass carefully.
Consult the local or national installation code(s) to
assure that adequate combustion and ventilation air is
available.
Installer l’appareil selon les codes ou reglements
locaux, ou, en l’absence de tels reglements, selon les
Codes d’installation CAN/CGA-B149.
DO NOT OPERATE THIS STOVE IF ANY PART HAS BEEN
UNDER WATER.
Call a qualified service technician to
inspect the heater and to replace any part of the con-
trol system and any gas control which may have been
under water.
Ne pas se servir de cet appareil s’il a ete’ plonge dans
l’eau, completement ou en partie. Appeler un tech-
nicien qualifie pour inspecter l’appareil et remplacer
toute partie du syste’me de controle et toute com-
mande qui ont ete plonges dans l’eau.
Hardware Bag Contents
• Fuel Conversion Kit - LP ...................................155592
* Decorative Pipe Brackets ...............................129469
Unpacking your stove
1. Remove the Top Plate of the stove by simply lifting it
straight off of the stove body.
2. To open the firebox, disengage the two Glass Frame
Latches located on top of the firebox. Pull each handle
forward to clear the latch from the notch in the frame.
3. Familiarize yourself with the installation requirements
specified in this manual, before beginning the installa-
tion.
Glass Frame
Latch
