22
137945_Rev_F 7.29.10
Figure 38. Brick Kit Contents
Optional Antique Brick Kit
# 155648
Figure 39.
Disengage the
compression latches
to remove the glass
frame.
Figure 41. Install Side Panel
Figure 40. Install Lower Rear Panel
CAUTION!
THE BRICK PANELS AND LOG PARTS ARE EX-
TREMELY FRAGILE. HANDLE WITH CARE.
Read these instructions before beginning the installation.
1. Remove the Top Plate.
Simply lift it up off of the stove
body. It is not fastened.
2. Remove the Glass Frame.
Disengage the two com-
pression latches located at the top of the firebox and
lift the glass frame up and off of the stove. See fig. 39.
3. If installed, remove the Logset.
These parts are not
fastened. Simply lift them out of the firebox. You do
not have to remove the embers.
4. Install the Lower Rear Panel.
Position it up against
the back wall, resting on the burner skirt. Fig. 40.
5. Install a Side Panel.
Tilt the panel, bottom edge first,
into position against the side wall. The panel will
stand on its own against the wall, fitting snugly be-
tween the rear panel and the front wall of the firebox.
Fig. 41.
6. Install the Upper Rear Panel.
Simply rest it on the
other two panels. Fig. 42.
7. Install the other Side Panel.
8. Reinstall the Logset.
Refer to the Owner’s Manual if
necessary. BE CERTAIN THAT NO EMBER STONES ARE
BLOCKING THE PILOT ASSEMBLY OPENING. Refer to fig.
36.
9. Replace the Glass Frame.
Slide the frame down the
slot in the front of the firebox. Be sure to push the
frame into the slot in the bottom to ensure it is fully
seated. The gasket at the top of the frame should be
flush with the top of the firebox.
Pull the compression latches out to engage with the
top lip of the glass frame.
10. Replace the Top Plate.
Figure 42. Install Upper Rear Panel
Lower Rear Panel
220990
Right Panel
220999
Upper Rear Panel
220745
Left Panel
220998
