15
137945_Rev_F 7.29.10
Log Set Installation
Brick Kit Note: Install the optional Antique Brick Kit
155370 before installing the logset.
See page 22 and the
instructions provided with that kit.
The GF 300 BV logset must be installed before operating
the burner. The logset includes four log pieces, pack-
aged inside the firebox, and a quantity of ember stones
packaged in the Miscellaneous Parts bag. To install the
log set, remove the packaging and place the parts inside
the firebox as illustrated in figures 20-24.
Do not handle
the log set with your bare hands. Always wear gloves to
prevent skin irritation from the ceramic fibers.
Figure 20. Engage the holes in the underside ot the Rear
Log with the two pegs in the burner skirt.
Figure 21. Install Right Log
Figure 22. Install Left Log
Figure 23. Install Middle Log
Figure 24. Position embers loosely and maintain 1/4”
clearance from the burner skirt edges.
1/4
6 mm
1/4
6 mm
Pilot
Assembly
KEEP CARRY-OVER
PORTS CLEAR
PN 220727
PN 220730
PN 220728
PN 220729
The ember stones realistically simulate glow-
ing coals when the burner is operating. These
should be spread evenly over the burner plate and
around the logs.
TO INSURE PROPER BURNER FUNCTION, DO
NOT OBSTRUCT THE PILOT ASSEMBLY AND BURN-
ER SKIRT OPENINGS WITH EMBER STONES. KEEP
EMBERS OFF OF THE PILOT CARRY-OVER PORTS. SEE
FIG. 24.
You do not need to use all of the ember
stones. With some experimentation, you will find
the arrangement and quantity of embers that
works best with your stove. Depending upon the
characteristics of your installation, it is possible
that too many ember stones can promote sooting
on the logs. Adjust the quantity of ember stones
as appropriate to maintain the best overall flame
picture and burner performance.
IMPORTANT
